Sharkoon BANDIT Especificaciones descargar pdf (Pagina 10)

BANDIT

5. Connect the 3.5" device to the power supply and the mainboard.

6. Screw the 5.25" bezel with 3.5" opening into the front panel and place it back

onto the case.

(5.25"bezelwith3.5"opening)

10. Installation of an add-on card

1. Presstheslotbezeloutofitsattachment(g.25).

ﬁg. 25

2. Insert the add-on card into the mainboard’s respective slot and screw it to

 thecase(g.26).

(Screwwithcoarsethread)

ﬁg. 26

11. The pre-installed fans

1. The pre-installed case fans provide a 4-pin PSU connector and a 3-pin

mainboard plug each.

2.ConnectoneofbothplugstoeithertherespectivePSUor(tocontrolthefan

 speedviathemainboard)thematchingmainboardconnector.

12. Installation of additional fans / optimized airﬂow

1. Placethefanagainsttherespectivebracketfromtheinside(e.g.theback

 side/g.27).

ﬁg. 27

1 2 ... 5 6 7 8 9 10 11 12

Sin comentarios

Sharkoon BANDIT Especificaciones Pagina 10